Gigabyte MU92-TU0 - Page 58

BIOS Setup - 58 -
Parameter
Description
ADR Data Save Mode
SpeciestheDataSaveModeforADR.BatterybackedorType01
NVDIMM.
Options available: Disable, Batterybacked DIMMs, NVDIMMs. Default
setting is NVDIMMs.
Erase-Arm NVDIMMs
Enable/Disable Erasing and Arming NVDIMMs.
Options available: Enable, Disable. Default setting is Enable.
Restore NVDIMMs
Enable/Disable Automatic restoring of NVDIMMs.
Options available: Enable, Disable. Default setting is Enable.
Interleave NVDIMMs
Controls if NVDIMMs are interleaved together or not.
Options available: Enable, Disable. Default setting is Enable.
Assert ADR on Reset
Enable/Disable Assert ADR on Reset.
Options available: Enabled, Disabled. Default setting is Disabled.
Assert ADR on S5
Enable/Disable Assert ADR on S5.
Options available: Enabled, Disabled. Default setting is Disabled.
Periodic Rcomp
Enable/Disable Memory Periodic Rcomp cycles.
Options available: Enabled, Disabled, Auto. Default setting is Auto.
Periodic Rcomp Interval
Selects Memory Periodic Rcomp interval. The possible values for
register COMP_INTERVAL are from 0 to 15. The time is indicated by
power (2, COMP_INTERVAL) x 10.24 usec.
Memory Topology
Press [Enter] to view memory topology with DIMM population
information.
MemoryRASConguration
Press[Enter]tocongureadvanceditems.

RAS Type
– Displays the RAS type.

New SDDC Mode
– Enable/Disable 48B SDDC ECC from ICX C0 Onwards.
– Options available: Disabled, Enabled. Default setting is
Enabled.

Mirror Mode
– Mirror Mode will set entire 1LM memory in system to be
mirrored, consequently reducing the memory capacity by half.
Enables the Mirror Mode will disable the XPT Prefetch.
– Options available: Disabled, Full Mirror Mode, Partial Mirror
Mode. Default setting is Disabled.

Correctable Error Threshold
– Correctable Error Threshold (1-32767) used for sparing, tagging,
and leaky bucket.
– Press the <+> / <-> keys to increase or decrease the desired
values.

Trigger SW Error Threshold
– Enable/Disable Sparing trigger SW Error Match Threshold.
– Options available: Disabled, Enabled. Default setting is
Disabled.