System Hardware Installation - 42 -
3-11 Removing and Installing the Power Supply
Follow these instructions to replace the power supply:
1. Flip up and then grasp the power supply handle.
2. Press the retaining clip on the right side of the power supply unit in the direction indicated.
3. Pull out the power supply unit using the handle.
4. Insert the replacement power supply unit rmly into the chassis. Connect the AC power cord to the
replacement power supply.
5. Repeat steps 1-4 for replacement of the second power supply.
3
1
2
4
Before you remove or install the power supply unit:
• Make sure the system is not turned on or connected to AC power.
To Next Page
Loading...
