Gigabyte R282-Z93 - Page 65

- 65 - BIOS Setup
Parameter Description
Legacy Console Redirection
Settings

Redirection COM Port
– Selects a COM port to display redirection of Legacy OS and Legacy
OPROM Messages.
– Options available: COM1/SOL / COM2. Default setting is COM1/
SOL.

Resolution
– On Legacy OS, the number of rows and columns supported in
redirection.

Options available: 80x24/80x25. Default setting is 80x24.

Redirection After BIOS POST
– This item allows user to enable console redirection after OS has
loaded.
– Options available: Always Enable/Boot Loader. Default setting is
Always Enable.
Serial Port for Out-of-Band
Management / Windows
Emergency Management
Services (EMS) Console
Redirection Settings

Out-of-Band Mgmt Port
– Selects a serial port to remotely manage a Windows server OS.
– Options available: COM1/SOL / COM2. Default setting is COM1/
SOL.

Terminal Type
– Selects a terminal type to be used for console redirection.
– Options available: VT100/VT100+/ANSI /VT-UTF8. Default setting
is VT-UTF8.

Bits per second
– Selects the transfer rate for console redirection.
– Options available: 9600/19200/38400/57600/115200. Default setting
is 115200.

Flow Control
– Flow control can prevent data loss from buffer overow. When
sending data, if the receiving buffers are full, a 'stop' signal can
be sent to stop the data ow. Once the buffers are empty, a 'start'
signal can be sent to re-start the ow. Hardware ow control uses
two wires to send start/stop signals.
– Options available: None/Hardware RTS/CTS. Default setting is
None.