Gigaset 2015 - Resetting Base Station to Default State

Important basic settings
24
Gigaset 2015 plus, GBR: A30852-X-1105-B301-1-7619
kap07.fm5
29.10.99
Resetting the base station to the default state
With this procedure you can change the following set-
tings back to the default (factory) state:
● signalling method (➔ page 16)
● length of pause after trunk code/main trunk code
(➔ page 19)
● assignment of ringing (➔ page 59)
● charge factor (➔ page 35)
● direct dialling-in (➔ page 59)
The following stored data is deleted:
● trunk code/main trunk code
● rate units/charges
The stored system code (➔ page 19) and the
messages/announcements on the answering
machine are not deleted. All logged-on hand-
sets remain registered.
B
#1
Start the procedure.
o
Enter the 4-digit system code (default: “0000”)
(➔ page 19).
O
250
B
Reset the base station to the default state.