Gigaset A280 - Using Multiple Handsets; Registering and Deregistering Handsets

16
Gigaset A280 / CHN / A31008-M2045-Y101-3-7619 / main.fm / 26.05.2010
Using several handsets
Registering handsets
Before you can use your handset, you must register it
to the base station. You can register up to four hand
-
sets. You must initiate handset registration on the
handset and on the base station.
On the base
¤ Press and hold the paging key Ëfor at least 5
sec.
On the handset
f(open menu)¢ADVANCED SET ¢|
¢REGISTRATION¢|
~
(enter current PIN, default: 0000) ¢|
The handset is assigned the lowest unassigned inter-
nal number (1–4).
Once the handset has been registered successfully, it
returns to idle mode. The name (default: Gigaset) and
the handset’s internal number is shown in the display,
e.g.
Gigaset 1.
If the handset was not registered successfully, the dis-
play will show PLS REG H/S. In this case repeat the pro-
cedure.
Deregistering handsets
Precondition: the handset is in idle mode.
f(open menu)¢ADVANCED SET ¢|
¢UNREGISTER¢|
~
(enter current PIN)¢|
¢p (select handset to be deregistered) ¢|
A long confirmation tone indicates the successful
deregistration. The handset display will show
PLS REG H/S.
Locating a handset ("paging")
You can locate the handsets using the base station.
Precondition: base station is in idle mode.
¤ Briefly press the paging keyË on the base sta-
tion.
All handsets will ring using a specific paging melody.
This also applies if the ringer tones are deactivated.
The displays will show
INTERCOM X .
In case of an incoming call, the handset quits the pag-
ing mode and then rings.
After 30 seconds handset and base station go back to
idle mode.
Ending paging manually
¤ Briefly press the paging key Ëon the base sta-
tion again.
Making internal calls
Internal calls are free calls to other handsets that are
registered to the same base station or to the base sta
-
tion itself.
Making internal calls (handset)
Calling another internal participant
k¢
~
(enter internal number of participant)
0 = base station, 1-4 = handset number, * = all
If only 1 handset is registered you need not enter a
number to call the handset from the base.
Accepting internal call
¤ To answer the call press c.
¤ To end the call, press a.
Incoming call during internal call
An incoming call is indicated by an acoustic signal.
c (answer external call, end internal call) or
k (hold internal call, accept external call)
¢ k(start conference)
Internal consultation calls
When you are speaking to an external participant,
you can call an internal participant at the same time
for consultation.
Press and hold k (put external call on hold)
k¢
~
(enter internal number of participant)
You are connected with the internal participant.
k (toggle between internal and external partici-
pant)
Please note
◆ The default system PIN may have been
changed,
(¢ page 19).
◆ The handset name can be changed,
(¢ page 18).
Please note
Do not deregister handsets unless necessary!