19
Gigaset A280 / CHN / A31008-M2045-Y101-3-7619 / main.fm / 26.05.2010
Changing the ringer volume
There are 4 levels of ringer volume (default: L2). You
can adjust the ringer volume.
Precondition: Base station is in idle mode.
¤ Press [ / \.
The current setting is shown on the display.
¤ To switch the ringer off completely (L0) press and
hold the
* key.
When switching the ringer off the key beep is also
deactivated.
Changing the PIN
The base station is protected via PIN against unau-
thorised handset registration. You can change the
preset PIN via menu.
f¢ADVANCED SET ¢|¢CHANGE
PIN¢|
¢
~
(enter current PIN, default: 0000) ¢|
¢
~
(enter new PIN: 0 to 9 digits) ¢|
¤ Use { as backspace.
Restoring to the factory settings
You can reset any individual settings and changes
that you have made.
Phone book and calls list entries are deleted. After
restoring the base, the handset(s) must be reregis
-
tered.
Precondition: handset and base are in idle mode.
Restoring the base
f¢ADVANCED SET ¢| ¢RESET¢|
¢p (select BASE) ¢|¢|
Restoring the handset
f¢ADVANCED SET ¢|¢RESET¢|
¢p (select HANDSET) ¢|¢|
Connecting to PABX
Your phone is preset at the factory for operation on
the main connection. For operation on a PABX, you
may have to change the following values. Please refer
to the user guide for your PABX.
¤ To change the handset settings use the menu.
f ¢ ADVANCED SET
Prefix setup
You can set a prefix which is automatically added to a
phone number with at least 5 digits. This prefix can be
used to dial into the outside line when operating the
device on a PABX.
Precondition: The number must be dialled in idle
mode, i.e. first
~
then ª.
f¢ADVANCED SET ¢|
¢AUTO PREFIX¢|
¢p(select ON or OFF) ¢|
~
(enter prefix, max. 4 digits) ¢|
¤ To enter a pause in the prefix press and hold Z.
Pause duration is one second by default.
Example: Prefix is ON and set to 65
Setting flash time
You can set the flash time to 100 (SHORT), 300
(
MEDIUM) or 600 (LONG) ms. (Default: SHORT)
¢f¢ADVANCED SET ¢|
¢FLASH TIME ¢|
¢p(select SHORT, MEDIUM or LONG) ¢|
Changing the dialling mode
You can set the dialling mode to PULSE or TONE.
(Default:
TONE)
f¢ADVANCED SET ¢|
¢DIAL MODE ¢|
¢p(select PULSE or TONE) ¢|
Please note
¤ If you have forgotten the PIN reset the base
unit to the factory settings to reset the PIN to
default setting 0000,
¢ page 19.
AUTO PREFIX
Set a prefix for dialling outside line.
FLASH TIME
Change the flash time.
DIAL MODE
Change the dial mode.
You dial Really dialled number
1234 1234
12345 65P12345
#12345 65P#12345
To Next Page
