MDE-3985L Encore® Installation Manual · May 2006 Page 5
Introduction
1 Introduction
Purpose of this Manual
This manual contains step-by-step instructions for installing Gilbarco
®
Encore
®
series pumps
and dispensers. Installation of these pumps is similar except for some differences in field
wiring and calibration. This manual does not include site preparation instructions
(see MDE-3802 Encore
and Eclipse
®
Site Preparation Manual). After the installation is
complete, a Gilbarco Authorized Service Contractor (ASC) must commission the unit to
activate the warranty. Reference information is contained within this manual for completing
MDE-4226 Encore/Eclipse Installation Checklist. Proper completion of the checklists is
required for commissioning of the unit. See Installation Checklists on page 12.
Encore Shipping Weight and Model Codes: N-X-X
Shipping Weights
The shipping weights for an Encore dispenser is approximately 800 lbs (363 kg). Additional
shipping weights are added when options are included. The following table provides shipping
weights for the dispenser and applicable option(s).
Model Codes
While new models have their serial plates located inside the bottom door, older units are
located at the bottom of the dispenser directly above the serial number. The serial number uses
a two letter and one number model code stamped into the serial plate. This code shows the
configuration and options of the Encore unit.
For example, a serial plate stamp that uses model code NG2" designate the unit as an
Encore Single-Hose 3 Grade Pump where:
N= represents an Encore unit
G= represents a single-hose
2= represents a 3 Grade Pump + 1
Refer to the following tables to determine the model code on a Gilbarco dispenser. Note that
not all model types are available in an E500/500 S or E300 series.
Equipment Weight (lbs) Weight (kg)
Dispenser 800 lbs 363 kg
Ultra-Hi (dual) 730 lbs 331 kg
VaporVac
®
option 200 lbs 91 kg
Pumping Unit option 60 lbs per grade 27 kg per grade
To Next Page
Loading...
Need help?
General
