38
Operation Instructions:
• Short press “¢” key: active the option;
•
Short press “p” key: select record interval; three options: “1s”, “4s” and “8s;
• Short press “¢” key: conrm the selection;
• Long press “¢” key: go back to the menu screen;
Note: The length of data record is constrained to at least 30 seconds, and
the maximal length for one record is also limited to 60 hours (for 1 second
interval), 240 hours (for 4 second interval) or 480 hours (for 8 second interval)
respectively.
3.2.7 Pulse Beep Settings
On menu screen, select “Pulse beep” and press “¢” key to enter Pulse Beep
Setting screen, as shown in Figure 19.
Figure 19 Pulse beep settings
The factory default is “OFF”; The latest setting status is that of you start the
oximeter next time.
3.3 Upload Data
Before uploading the data to PC, please quit from the menu screen if you are
doing the setup or trend view operation.
Before uploading, connect the USB data cable between the oximeter and PC.
• Do the following operations by the instruction in “Oximeter Data Manager User
Manual”, then the data uploading will be activated.
• Copy the data from the oximeter to PC (or other host device) as the oximeter
will be mapped as a removable disk when it is connected to PC by USB data
cable.
3.4 Low Battery Indication
If “ ” appears on the screen, it indicates that battery power is not enough,
please change batteries. If you keep on using it, after a while the batteries are
exhausted and the oximeter will be off
ENGLISH
To Next Page
Loading...
