Maintenance
Daily cleaning of the equipment
The manufacturer recommends the following at the end of each working day.
-
Clean showers, group gaskets, group flange with a brush.
-
Wash filters and filter handles in warm water adding a special detergent product (for use with coffee machines).
-
Back flushing: Put the blind filter firmly inside the filter holder (removing the filter which might be in the filter
holder). Pour 1 spoon of special coffee machine food quality detergent inside the blind filter and insert the filter holder
firmly inside the coffee brewing head. Set down the group lever. Set up it after 10 seconds. Wait another 10 seconds
and press set down the lever again. After 10 seconds set up again. Repeat these operations for 3 times. When you’re
done, make sure the the lever is set up, and remove the filter holder and rinse water on top of the blind filter inside the
filter holder. This is to remove residuals of the cleaning product. Now insert the filter holder with the blind filter inside
again firmly into the group. Set down the lever and let the system rinse for 20 seconds. Set up the lever again to
terminate the back flushing / rinsing operation. Take the filter holder out of the group and remove the blind filter. Do
not leave the filter holders inside the group when machine isn’t used over night. This will increase the lifetime of the
group gaskets.
-
Clean the cups tray and grid without removing the tray from the machine.
-
Clean the hot steam wand and spout accurately with a clean non-abrasive damp cloth after each single use
without touching it directly with any part of the body to avoid injury or damage due to the hot surface of the spouts.
Caution: Hot surfaces.
-
When necessary clean the metal parts of the bodywork carefully with a clean non abrasive cloth without touching
it directly with any part of the body to avoid injury or damage due to the hot surface of the spouts.
Caution: Hot surfaces.
Turn the machine off prior to proceed to the following operations:
-
Clean the drip tray and grid.
- Clean the plastic recipient located in the part under the drip tray. Use a spoon for this purpose.
- Clean the bodywork with a non-abrasive damp cloth.
Never use aggressive products or alcohol.
To Next Page
Loading...
