Gime AMBRA - Some Information on Installation

Manuale d’uso per machine da caffè GIME. Con riserva di modifiche.
User Manual for GIME Espresso Coffee Machines. Specifications subject to change without notice.
20
Some information on installation
Installation and maintenance must only be carried out by technicians and service providers authorised by the
manufacturer.
The manufacturer has tried to foresee all possible safety devices to ensure the safety of the users.
Anyhow different conditions of installation or of equipment moving can cause situations which cannot be controlled
or foreseen. Therefore it’s absolutely necessary to evaluate all remaining risks and to care about the following
suggestions:
Do not leave such packing items as plastic bags, styrofoam, nails, etc. around because children or other people could
get hurt or damaged.
Any defect or discrepancy has to be notified immediately to the authorised persons for installation and maintenance.
This machine is safe only when it has been correctly connected to an efficient earthing system, implemented in
accordance with the current safety regulations.
All electrical connections have to be effected exclusively by authorised and qualified technicians.
Any improper cable connection is forbidden.
Check the integrity of all components and do not install defective or damaged parts. Ask for substitution.
Check that capacity of the electrical system is sufficient for the maximum rated power shown on the rating plate of the
machine.
The customer has to protect the electrical feeding of the machine by means of a safety switch system.
The machine has to operate with soft water. The water hardness being between:
- 50 to 100 American degrees
- 7 to 14 German degrees
- to 8 French degrees
Building up of scale will seriously damage the equipment and can also cause injury!
The instruction for installation of class I appliances of the professional type which are intended to be permanently
connected to fixed wiring, the leakage current of which may exceed 10mA, states that the installation of a residual
current device (RCD) having a rated residual operating current not exceeding 30mA is advisable.
Means for disconnection with contact separation in all active (phase) conductors. The means for disconnection must
be incorporated in the fixed wiring according to the wiring rules
Height of the support on which the machine is to be installed: this height has to be at least of 105 cm.
This equipment is to be installed to comply with the applicable Federal, state, or local plumbing codes having
jurisdiction.