13
WARNING: If you are in any doubt about any
aspect of rescue installation, seek professional
advice!
IMPORTANT: You must perform a test
deployment from a simulator to verify the
installation.
Rescue Installation and compatibility check
Gin Gliders recommend that rescue installation is performed properly by a competent person. The
rescue parachute is a pilots last resort and failure to pack or connect the reserve parachute in the correct
way may cause death or severe injury. The pilot is responsible for ensuring proper installation.
This harness is compatible with the G-Lite, Yeti and Yeti Cross rescue parachutes. Other manufacturers’
rescues may also be used but we cannot guarantee their function. The pilot is responsible for checking
compatibility.
Every first installation of a rescue system into the harness (that means every new combination of
harness and rescue system) must be checked by a qualified paragliding professional for compatibility. To
verify the installation, you must perform a test deployment by sitting in a simulator.
Rescue should be repacked upon the recommendations of the rescue manufacturer. After every repack of
the rescue parachute you should also do a compatibility check.
Rescue compatibility
MAKE SURE THAT THE RESCUE PARACHUTE CAN BE RELEASED FROM THE RESCUE CONTAINER—it must be
done by you, the pilot, sitting in the harness hanging from a simulator.
To Next Page
Loading...
