SETUP FOR SWITCH
WIRELESS PAIRING
The controller includes a rechargeable battery that was charged at the time of
manufacturing. If the LED bar flashes red, then the battery needs charging.
To charge, connect to the Switch console or another USB power source via the
USB cable.
From the Switch home menu, select ‘Controllers’ then select ‘Change Grip/Order’. While the following screen is displayed, press and
hold the Home button on the controller you are pairing. Release the Home button and the LED bar starts flashing indicating the
controller is ready to pair.
NOTE: Aer the controller is paired to the Switch, it will automatically connect next time.
WIRED COMMUNICATION OPTION
The controller can communicate with the console via USB (wired) mode. By default, the Switch console has wired communication disabled. Enable
wired communication by going to System Settings / Controllers and Sensors / Pro Controller Wired Communication and set it to On. Connect the
USB charge cable to the controller and Switch console for USB mode.
When you want to use the controller in wireless mode again, disconnect the USB charge cable from the controller, and press the Home button to
wirelessly reconnect to the Switch console.
03
To Next Page
Loading...
Need help?
General
