Glentronics Basement Watchdog SP-33T - User Manual

Specifications 1/3 HP Model SP-33T 1/2 HP Model SP-50T
GPH @ 0’ 3700 3900
GPH @ 10’ 2800 3100
Pump diameter 9.5” 9.5”
Volts 115V, 60Hz 115V, 60Hz
Amps 4.2 5.5
I
mportant Safety Instructions
SAVE THESE INSTRUCTIONS. This manual contains important SAFETY WARNINGS and
OPERATING INSTRUCTIONS for the Basement Watchdog pumps. You will need to refer to
it before attempting any installation or maintenance.
ALWAYS keep these instructions with the unit so that they will be easily accessible.
Failure to read and follow these warnings and instructions could result in property
damage, serious injury, or death.
• ALWAYS disconnect the pump from the power source before servicing or making
adjustments.
• NEVER handle the pump or motor with wet hands or when standing on a wet or damp
surface while the pump is plugged into the power source.
• MAKE SURE THERE IS A PROPERLY GROUNDED RECEPTACLE AVAILABLE. This pump is
wired with a 3-prong grounded plug. To reduce the risk of electric shock, be certain
that it is only connected to a properly grounded, 3-prong receptacle. If you have a 2-
prong receptacle, have a licensed electrician replace it with a 3-prong receptacle
according to local codes and ordinances.
• NEVER bypass grounding wires or remove the ground prong from the plug.
• DO NOT use an extension cord. The electrical outlet should be within the length of the
pump’s power cord, and at least 4 feet above the floor level to minimize potential
hazards from flood conditions.
• DO protect the electrical cord from sharp objects, hot surfaces, oil, and chemicals.
Avoid kinking the cord.
• MAKE SURE the supply circuit has a dedicated fuse or circuit breaker rated to handle
the power requirements noted on the nameplate of the pump.
• DO NOT use the power cord or strain relief to carry the pump. Use the pump handle.
• DO NOT operate the pump if it has been damaged in any way.
• DO NOT use sump pumps in pits handling raw sewage, salt water, or hazardous liquids.
This pump is for ground water use only.
• DO NOT use in continuous duty applications such as fountain ponds. This pump is rated
for intermittent use only.
• DO NOT disassemble the pump or float switch. When service is required, contact
Glentronics technical support at 800-991-0466, option 3. Return the product to the
manufacturer for any repairs at the following address:
Glentronics, Inc., 645 Heathrow Drive, Lincolnshire, IL 60069
Risk of electric shock. To reduce this risk, observe the
following precautions.
To reduce the risk of hazards that can cause injury or
property damage, observe the following precautions.
Basement Watchdog
Sump Pumps
Instruction Manual &
Safety Warnings
Items Included:
Pump with tether float switch
You may also need:
A 1-1/2” PVC pipe adapter to screw into the discharge hole near the
bottom of the pump
1-1/2” rigid PVC pipe to connect to the existing plumbing
A check valve or rubber union
PVC pipe cleaner and cement
Wire ties or hose clamps
Models SP-33T and SP-50T
!
WARNING
!
CAUTION

Summary

Important Safety Instructions

WARNING

Risk of electric shock. To reduce this risk, observe the following precautions.

CAUTION

To reduce the risk of hazards that can cause injury or property damage, observe the following precautions.

Installation Instructions

Prior to Installation

Steps to take before beginning the pump installation process.

Connecting the Pump

Instructions for connecting the sump pump to the electrical power source.

Completing the Installation

Final checks and procedures after the pump has been installed.

Product Operation

Tether Float Switch

Details on how the tether float switch functions and how to adjust it.

Troubleshooting

The pump will not start or run

Common reasons and solutions when the pump fails to operate.

Thermal protector tripping or not functioning

Diagnosing issues related to the pump's thermal protection.

Pump starts and stops too frequently

Addressing rapid cycling issues of the sump pump.

Pump will not shut off

Solutions for when the pump fails to stop after evacuating water.

Insufficient or no water volume

Troubleshooting low water flow or no water output from the pump.

Abnormal sound or vibration

Identifying and resolving unusual noises or vibrations from the pump.

Limited Warranty

What is Covered by this Warranty?

Details on what parts and labor are covered under the warranty.

What is NOT Covered by this Warranty?

Exclusions from warranty coverage, including improper installation or damage.

How to Obtain Warranty Service

Procedure for returning a product for warranty service.

Glentronics Basement Watchdog SP-33T Specifications

General

Model	SP-33T
Category	Water Pump
Brand	Glentronics
Type	Submersible
Horsepower	1/3 HP
Voltage	115V
Discharge Size	1-1/2 in
Warranty	3 years
Power Source	Electric
Switch Type	Vertical Float
Power Cord Length	10 feet