Gliderol Glidermatic GRD - Troubleshooting Fault Table

Operating
Controls
Gontinued)
10) Con 1
External
Light Accessory Board
connection
11) Con
2
Externa I Alarm/Si ren Accessory Boa rd con nection
12) Con 3
External
LED Status Indicator Accessory
Board
connectron
13)
Con 4
Front Cover Push Button Connection
14) Js
External counter connection
1s) t1
Motor loom connection
16) t4
Transformer
Connection
(24VAC
Cn
)
17)
tP1 | tPz I tP3
Transmitter
button configuration
(set
up
)
18) U9
Remote
switch connection / Photocell
connection
.^.
Up Direction
t
Sron
17
Down Direction
12V 12V
DC
O
Photocell
lt
I t
uB DowN, sroP
GND Ground
19) Radio
Receiver
This receiver is factory
preset
and has no user
adjustment.
Please DO NOT adjust
any the tuning caps.
Before
you
call
your
local
Gliderol agent
please
check the following Fault Table
Door does not operate
,*
Check electrical supply to unit.
"+
Press hand set and/or bell
press
button again.
drtve
(move
door
man.rally
to re-enqaqe).
Drive motor operates when red Pin Hand{e is engaged but door
does
not move.
Pin
is
broken and requires replacing.
Check by attempting the
move door manually
when the motor has stopped running.
4. Door auto-reverses after closino fullv
Check setting of cams relative to
the
lower limit
switch
-
unil
must
stop using the limit switch NOT by
5. Door stalls at fully open
position
and continues to try
to open
the door
rf
button
is
pressed
again.
Check setting of cams relative
to
the upper limit
switch
-
unit
must
stop using the limit switch NOT by striking the
guide
top
stop.
6. Door open and closed
positions
incorrect
(Stop
short)
Adjust
cams relative to the Iimit switches until required
positions
are achieved.
7. Courtesy
iight
comes on but door does not move.
Check that the Drive
Unit
is
plugged
in
and motor operates.
Check that the Red Pin Handle is engaged.
B.
Hand set range diminishes.
'*
Replace hand
set battery after
'1
2 months.
'*
Check
position
of antenna on unit to ensure it is relatively
straight
and
not
adjacent to the
power
cord.
o u:nrl
(ai
.1^a< n^r ^nen
dOOf.
i4
Replace hand
set battery after
6
-
12 months.
"*
Check
position
of antenna on unit to
ensure it
is
relatively
straight and not
adjacent to the
power
cord
,-
Check
that the
hand
set has been
programmed
for the door.
10.
Door
auto-reverses
before it
is closed
Check the sensitivity setting on the
circuit board.
Check the door is not
jammed
in tracks.
11 Door stops during opening.
Check the sensitivity setting on the circuit board.
Check
the
door is not
jammed
jn
tracks
12. Door does not operate and the courtesy lamp is not
on.
,*
Check
power
is switched on.
,*
Check fuse on circuit board anci replace.
,-
Check the door is not
jammed
in tracks.
/
t
e.G^kl?"'T8-L
GRD OWNERS
MANUAL PAGE
8