17
Bolt A: Use of existing motorcycle bolts +
Bolt C: M8 55mm / hex socket head bolt+
Bolt D: M8 25mm / hex socket head bolt
Spring washer
ⓐ
ⓑ
ⓒ
ⓓ
ⓕ
ⓔ
ⓖ
Nut B: M8 55mm / hex socket head bolt +
Spring washer
Spring washer
Bolt E: M10 55mm / hex socket head bolt +
Bolt F: M10 10mm hairless wrench bolt Bolt +
Bracket cover
Bolt G: M6 10mm round head bolt
Spring washer
Bracket parts
Mount bracketMiddle bracket
Sliding bracket
Fix the mount bracket using “A” and “B” bolts at the place where the footrest was removed.(It is
recommended to work after removing the muffler cover as there is interference.)
Fasten the foot stand bracket using bolt “C” and install the
slide bracket using bolt “D”.
Connect the blue wire of the switch to ACC, and insert the
switch cable into the control box.
※ Bracket modeling is subject to change due to design modification.
※ Bracket bolt dimensions are subject to change due to modeling
modifications.
To Next Page
Loading...