Global 761221 User Manual

globalindustrial.ca
Distribucion Industrial Globales S DE RL DE CF
Instruction Manual Manual de Instrucciones Manuel d'instruction
Customer Service
US: 1-800-645-2986
Servicio de atención al Cliente
México: 01.800.681.6940
Service à la clientèle
Canada: 888-645-2986
1
Outdoor Bi-Level Drinking Fountain
w/ Bottle Filler & Pet Station
Models 761221, 761221BK,
761221BL & 761221GN
• All installation work must be performed by authorized
service personnel.
• Two or more people are recommended to lift and
install the unit.
• To avoid the risk of property damage and/or personal
injury, ensure the mounting surface is adequate to support
450 lbs.
• Check local codes for plumbing requirements prior
to installation.
• Refer to Rough-In Guide (page 4) prior to installation.
• Thoroughly flush all water supply lines of all foreign
matter before connecting to the fixture.
• Check for any leaks before use.
• DO NOT attempt to repair or replace any part of this
fountain unless it is specifically recommended in this
manual. All other services should be referred to a
qualified technician.
• For use with clean, clear potable drinking water only.
• Shut-off water supply during installation to reduce the
risk of water damage.
• Freezing Caution: Before freezing temperatures occur,
refer to the Draining and Winterization section of this
manual (page 13) for proper preparation.
• Installation of a trap on the water drain line may be
necessary; remove trap before winterization draining.
• Failure to follow safety warnings and/or
installation instructions will void warranty.
WARNING
Note: This unit is designed to be installed on the surface of an existing or new concrete slab.
Included are the necessary vandal-resistant stainless steel bolts and washers needed
to anchor this unit. Installer must provide a 1-1/2” PVC drain line (if applicable) and water supply
line. All connections are made inside the item through the access doors, as shown in the drawings.
It is recommended to install a shut-off valve (not included) on the water supply.

Global 761221 Specifications

General

Material	Resin
Number of Tiers	3
Pump Included	Yes
Water Flow	Adjustable
Type	Tiered
Power Source	Electric

Summary

General Safety Warnings

Specifications

Part Breakdown

Required Tools

Rough-In Guide

Installation

Remove Access Panels

Remove all access panels using the provided torx key wrench or drill bit to access connections.

Install Bubblers

Secure bubblers to the drinking fountain pan surfaces using nuts and washers.

Mount Pedestal to Ground

Secure the fountain base to a solid surface using the provided anchor kit and mounting hardware.

Attach Bottle Filler to Pedestal

Assemble the bottle filler to the pedestal using M6 x 10 pan head screws.

Attach Drinking Fountain to Pedestal

Assemble the drinking fountain to the pedestal using H5, H6, and H7 hardware.

Connect Water Inlet Lines

Connect water inlet lines to the spout, push button, and bubbler as illustrated.

Water Pressure and Warranty Caution

Adheres to water pressure limits (20-105 PSI) to avoid voiding warranty.

Connect Water Drain Lines

Connect water drain lines to the bottle filler and drinking fountain drains using provided fittings.

Attach Pet Station to Pedestal

Attach the pet station to the pedestal using provided M6 flat head screws.

Start-Up Procedure

Purge air from water lines by pressing the push button until a steady stream is achieved.

Stream Height Adjustment

Adjust water stream height using a flathead screwdriver through the push button access hole.