Global JUNO-NET - Operation; Description of the fire control panel fascia

JUNO-NET
CONTENTS
SECTION 1 -
1.1 Description of the fire control panel fascia................................................
1.2 Alarm.................................................................................................
1.9 Caretaker Test Mode.............................................................................
1.10 Disablements......................................................................................
1.10.1 Selected detectors..............................................................
1.10.3 Fire Brigade Transmission....................................................
2.1 Printer paper replacement.....................................................................
2.2 SIM CARD replacement.......................................................................
2.3 Main control board fuse........................................................................
2.4 Connection board fuses........................................................................
2.5 Sub-panel fuses...................................................................................
2.6 Battery voltage and charger checks.........................................................
2.7 Use of programming functions for maintenance.......................................
2.8 Getting into Programming Mode............................................................
2.9 Logbook.............................................................................................
2.10 Event data sheet...................................................................................
OPERATION
1.3 Reset the system...................................................................................
1.4 Sound and silence the alarms.................................................................
1.5 Read the Fire, Fault, Test and Disabled queues..........................................
1.6 Active Delays.......................................................................................
1.7 Lamp Test............................................................................................
1.8 Perform a fire drill.................................................................................
1.10.2 Auxiliary relays...................................................................
1.11 If the panel displays a fault.....................................................................
1.12 If the panel displays a pre-alarm............................................................
SECTION 2 -
MAINTENANCE
2
4
5
5
6
7
8
9
10
12
12
13
13
14
14
15
16
17
17
17
18
19
22
27
28
This manual has been written for panel software revision 2.05. Older or new
versions of panel software will be similar but some details may differ.
1
OPERATION & MAINTENANCE MANUAL
REVISION 0.7a
16-04-2004