USER’S MANUAL
SYSTEM/VECTOR
CHAPTER 9
9. MAINTENANCE
Scheduled maintenance is limited to general cleaning of the Vector at the
end of the work shift and after vehicle repair cycle.
Maintenance of the hydraulic pump must only be performed by
Qualified Personnel following the instructions given in the User’s
Manual supplied with the pump itself.
9.1. CHECKS AND MAINTENANCE OPERATIONS
The notched plate and the Bench securing bracket must be kept free of dust
and dirt, oil deposits and any other form of dirt that may fall from the
vehicle being repaired.
The operations required for the hydraulic cylinder are limited to a periodic
“visual” check for any oil leaks. A dry unit, free of any traces of oil indicates
that the hydraulic circuit is tight. Check and if necessary tighten the
connections.
WARNING
For general cleaning operations, do not use water,
gasoline or flammable liquids. Use rags or paper
and possibly jets of dry, compressed air.
PERIODICALLY CHECK THE SCREWS ON THE HALF RINGS FOR TIGHTNESS.
To Next Page
Loading...
