USER’S MANUAL
SYSTEM/VECTOR
CHAPTER 5
5. INSTALLATION
5.1. Bench SYSTEM on wheels
Each operation of assembling, disassembling and substitution of wheels
and/or crossbeam of wheel supports must be done without any vehicle on
bench.
In case of equipments present these must be fixed in manner that they
cannot move in any direction.
The lifting bracket B4525 (see page 33 of this manual) must be used
exclusively when the bench is unloaded.
In case of urgent and immediate intervention use a hydraulic jack (of
adequate lifting capacity) directly on the lower profile of the bench paying
attention and applying always the elementary rules of security.
MAXIMUM WEIGHT CAPACITY OF THE BENCH SYSTEM ON WHEELS Kg 3100.
5.2. HANDLING the SYSTEM bench and VECTOR arm (see page 19)
Once the work area has been selected, move the package into position with
a forklift or lift truck.
The package containing the “VECTOR” appears as indicated in
(Fig. 05-01)
The SYSTEM and VECTOR must be installed by Qualified Personnel carefully
following the instructions given in this Manual.
To Next Page
Loading...
