USER’S MANUAL
SYSTEM/VECTOR
CHAPTER 5
5.3. UNPACKING
Remove the lid and open one side of the crate. Withdraw all the wooden
parts used to lock the unit in place during shipping. Withdraw the vertical
body and then push out the horizontal body on its own wheels.
WARNING
Be very careful when performing this operation.
Make certain that the wheels do not bang against
the floor when the unit is removed from the crate
as they could break.
List of the components contained in the package (Fig. 05 - 02)
- A horizontal body with tool-holding
pocket.
- A vertical body complete with snub
pulley chain.
- Upper connection and lower fork
connection for application of the
hydraulic cylinder.
- A 36 mm. combo hexagonal wrench
(to secure the VECTOR to the
Bench).
To Next Page
Loading...
