Page 7
Installation
INSTALLATION
1. Read this manual thoroughly before installation and operation. DO NOT proceed with installation and
operation if you have any questions or do not understand anything in this manual. Contact your local
representative or Globe rst.
2. Remove the grill from the box. Once your grill has been removed from the packaging, be certain that all
protective plastics and residues are removed from all surfaces.
3. Select a location for the grill that has a level, solid, nonskid surface that is nonammable and away
from water hazards or sinks and is in a well-lighted work area away from children and visitors.
4. Inspect the grill to ensure all parts have been provided (i.e. - catch tray, feet x4, grooved scraper - supplied for
the grooved panini plate grills only).
5. The installation of the grill must conform to the NATIONAL ELECTRIC CODE AND ALL LOCAL ELECTRIC
CODES AND ORDINANCES AND ALL THE LOCAL ELECTRICAL COMPANY RULES AND REGULATIONS.
Additionally, we recommend that the grill is allowed a 4” spacing surrounding the unit in order to provide
adequate ventilation.
6. Model GPG10, GSG10, GPG14D, and GSG14D ---- 120V
These grills are wired for use with a 120V/AC receptacle and may be plugged in to any convenient outlet. Due
to the high current draw, these units should be operated on a dedicated, correctly rated circuit.
Model GPGDUE10 , GSGDUE10, GPGDUE14D, & GSGDUE14D --- 240V/AC
These grills are wired for use with a standard 240V/AC receptacle and may be plugged in to any
convenient outlet. Due to the high current draw, these units should be operated on a dedicated, correctly rated
circuit.
7. Proper connections and power supply are essential for efcient performance.
8. The external wiring should be in conduit or an approved type of exible cable suitable for operation at
temperature indicated at the conduit hole and in a proper size to carry the load.
9. The supply circuit should be properly fused and equipped with a means of disconnecting, as required by the
local electrical code. For a grill with plugs and leads set, simply provide a suitable power point and connect.
The Globe electric panini grill is equipped for the voltage indicated on the nameplate
mounted on the rear of the unit. This panini grill is designed for use on alternating
current (AC) only.
This equipment gets EXTREMELY HOT so make sure all ammable/combustible
materials are set away from this equipment.
NOTE: Panini Grill top plate tension can be adjusted with the included allen wrench. Ajust to lifting tension
likeness.
To Next Page
Loading...
Need help?
General
