Page 6
Installation
UNPACKING
Unpack the fryer immediately after receipt. If the machine is found to be damaged, save the packaging material and
contact the carrier within fteen (15) days of delivery. Immediately contact Globe or your local dealer of the equipment.
You have no recourse to damage after fteen (15) days.
TO AVOID SERIOUS PERSONAL INJURY:
• ALWAYS install equipment in a work area with adequate light and space.
• ONLY operate on a solid, level, nonskid surface that is nonammable and away from sinks and water hazards.
• NEVER bypass, alter or modify this equipment in any way from its original condition. Doing so can create
hazards and will void warranty.
• NEVER operate the fryer without all warnings attached to unit.
NOTICE: Local codes regarding installation vary greatly by area. The National Fire Protection Association, Inc, states in
its NFPA 96 latest edition (see below) that local codes are “authority having jurisdiction” when it comes to
requirements for installation of equipment. Therefore, installations should comply with all local codes. Once your electric
fryer has been removed from the packaging, be certain that all protective plastics and residues are
removed from all surfaces.
PROPER GROUNDING
THIS MACHINE IS PROVIDED WITH A THREE-PRONG GROUNDING PLUG. THE OUTLET TO WHICH THIS PLUG
IS CONNECTED MUST BE PROPERLY GROUNDED. IF THE RECEPTACLE IS NOT THE PROPER GROUNDING
TYPE, CONTACT AN ELECTRICIAN. DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR
REMOVE THE THIRD GROUND PRONG FROM THE POWER CORD OR USE ANY ADAPTER PLUG (Fig. 6-1 and
Fig. 6-2).
1. Complete the intallation/warranty registration online at:
www.globefoodequip.com/support/warranty-registration-form.
2. Electric fryer outside covering/containment unit, oils and baskets will be HOT during and after use. Use
caution when approaching the unit.
Electrical
Model PF10E
The PF10E -120V Fryer is wired to use with a standard 120VAC receptacle and may be plugged in any convenient
outlet. (USA only) This unit requires 14.2 amps to produce 1700 watts and should be used on a dedicated circuit.
Models PF16E & PF32E
The PF16E & PF32E -208/240V Fryers. (USA only) The PF16E requires 15.8A to produce 2900W-3800W and should be
on a dedicated service. (USA only) The PF32E requires 31.6A to produce 5800W-7600W and should be on a dedicated
service.
Fig. 6-1 Correct Fig. 6-2 Incorrect
To Next Page
Loading...
General