Supplied By www.heating spares.co Tel. 0161 620 6677
19
Diagram 7.1
A - Central Heating Isolation Valve
B - Domestic Hot Water
C - Gas Service Cock
D - Domestic Cold Water
E - Washers (not shown)
F - Condensate Connection
G - Safety Discharge Valve
7 Gas / Water & Appliance Connection
7.2 Appliance Connection
IMPORTANT: With regards to the Manual Handling Opera-
tions, 1992 Regulations, the following lift operation exceeds
the recommended weight for a one man lift, refer to section 16
Manual Handling.
NOTE: The appliance may contain a small amount of water,
place a water container beneath the boiler connections.
Lifting the boiler into position, lean the top of the boiler slightly
to the wall and position just above the hanging bracket. Low-
er the boiler slowly push back and engage onto the hanging
bracket.
Remove the protective caps.
Do the connections, interposing the sealing washers supplied
in the Loose Items pack.
Make good the fi nal connections.
G
Numbers 1 - 5
show the sequence to be
used when tightening to
copper tails.
A A
F
B D C
1 2 43 5
To Next Page
Loading...
