0020094626_00 - 06/10 - Glow-worm
- 3 -
INTRODUCTION
1 Instructions guidance
1.1 Product documentation
The instructions are an integral part of the equipment and must
be handed to the user on completion of the installation in order
to comply with the current regulation.
• Carefully read the manual to allow for safe installation, use
and servicing. No liability can be accepted in the event
of damage for not complying with the guidance in this
instruction manual.
1.2 Associated documents
- User instructions
1.3 Explanation of symbols
e
DANGER: Risk of electric shock.
ATTENTION: Risk of damage to the equipment or
to its surroundings.
IMPORTANT: Important information.
2 Product description
2.1 Regulation and statutory requirements
CE Mark
The CE mark indicates that the equipment described in this
manual are in compliance with the following directives:
- European Directive Num. 2004-108 of the European
Parliament and the Council regarding electromagnetic
compatibility
- European Directive Num. 2006-95 of the European
Parliament and the Council regarding low voltage
- Directive regarding telecommunications equipment (
Directive R & TTE 99/5/EEC of the Council of the European
Community)
- Low Voltage Directive 72/23/EEC.
2.2 Block diagram
EBUS
230V
IN
OUT
NTC
1
2
3
4
5
6
7
Key
1 EBUS connections
2 Input/Output, sensors
3 230 V power supply
4 Control unit
5 Wireless outdoor sensor
6 Room thermostat
7 Batteries
3 Safety instructions and regulations
3.1 Safety instructions
e
Incorrect installation can cause electric shock or
appliance damage.
All electrical work performed on the equipment must be carried
out by a qualifi ed engineer or Glow-worm Group Service
engineer.
This equipment must only be installed by a qualifi ed and
engineer, to ensure that the applicable regulations and rules are
adhered to.
Follow the basic safety instructions:
• Stop the control unit.
• Turn off the control unit’s power supply.
INTRODUCTION
To Next Page
Loading...
Need help?
General
