6
6. Setting the reminder alarm
Your meter has four reminder alarms. The meter will display “OFF” and “ ”. If
you don’t want to set an alarm, press S to skip this step. Or press M to
select “On”, then press S.
With the hour/minute ashing in sequence, press M to select the correct
hour/minute. Press S and go to the next alarm setting.
NOTICE:
At the alarm time the meter will beep and automatically switch on. You can press
M to silence the alarm. If you do not wish to perform a test, press and hold M to
switch the meter o. If you do not silence the alarm, the meter will beep for 2
minutes then switch o.
Congratulations! You have completed all settings!
NOTE:
• These parameters can ONLY be changed in the setting mode.
• If the meter is idle for 2 minutes during the setting mode, it will switch o
automatically.
To Next Page
Loading...
