GMI D1033D - Mounting and Removing Units from DIN-Rail; DIN-Rail Mounting Procedure

Technology for safety
8
D1000 series - Intrinsically Safe Isolators
Mounting and Removing units from DIN-Rail
Mounting
Removing
Fig. 1 Fig. 2
Fig. 3
To remove a barrier from the mounting rail, insert the blade screwdriver in the metallic part of the mounting foot and lever the spring catch open
against the side of the barrier casing (see Fig.3).
Push
To
engage
To mount Series D1000 on 35 mm DIN Rail, hook one side of the mounting foot over the lip of the rail and press down firmly on the barrier
(see Fig.1) to snap the other side of the mounting foot over the opposite rail lip (see Fig.2).
Metallic
Part
Spring
T35 DIN Rail
Screwdriver
T35 DIN Rail
T35 DIN Rail