Press function button 2 < >
button so that < > is displayed
on the LCD panel.
● If you set a shutter speed that is the same as or slower
than the camera’s maximum flash sync speed, < >
will not be displayed in the viewfinder.
● With high-speed sync, the faster the shutter speed, the
shorter the effective flash range.
● To return to normal flash, press < > button again.
Then < > will disappear.
● Multi flash mode cannot be set in high-speed sync
mode.
● Over-temperature protection may be activated after 15
consecutive high-speed sync flashes.
1
2
1
2
3
Press function button 3
< >. The icon < >
and the exposure bracketing
amount will be highlighted
on the LCD panel.
Press Set Button again to
confirm the setting. Then
your FEC and FEB settings
are displayed on the LCD
panel.
Set the flash exposure
compensation amount.
● Turn the Select Dial to set
the amount.
● “0.3”means 1/3 step,
“0.7”means 2/3 step.
1
Press Function Button 2
< > so that < > is
displayed.
2
Check that < > is displayed
in theviewfinder.
● FEB will be cancelled after three photos are taken.
● For best results, set the camera drive mode to “single” and
ensure the flash is ready before shooting.
● FEB can be used with FEC and FEL.
You can prevent the FEB from being cancelled
automatically after three photos are taken. (C.Fn-FEB
ACL , Page 55)
C.Fn
FEL: Flash Exposure Lock
FEL can lock the correct flash exposure setting for any part of the
scene.
With <ETTL> displayed on the LCD panel, press the camera’s
<FEL> button. If the camera does not have the <FEL> button, press
the < * > button.
Focus the subject.
Press the <FEL> button.
● Aim the subject at the
center of the viewfinder and
press <FEL> button.
● The camera flash will fire
a preflash and the required
flash output for the subject
is retained in memory.
● If the subject is too far away and underexposure, the < >
icon will blink in the viewfinder. Move closer to the subject
and try the FE lock again.
● If <ETTL> is not displayed on the LCD panel, FE lock
cannot be set.
● If the subject is too small, FE lock might not be very
effective.
High Speed Sync (FP flash) enables the flash to synchronize with
all camera shutter speeds. This is convenient when you want to use
aperture priority for fill-flash portraits.
Second-Curtain Sync
With a slow shutter speed, you can create a light train following
the subject. The flash fires right before the shutter closes.
High-Speed Sync
●"FEL" will display on the viewfinder for 0.5s.
●The camera flash will fire a preflash and lock the flash exposure
setting once the <FEL> button is pressed.
- 33 - - 34 -
To Next Page
