To Next PageTo Next Page
Need help?Do you have a question about the Godox V1Pro O and is the answer not in the manual?
General| Power | 76 Ws |
|---|---|
| Channels | 32 |
| Type | On-Camera |
| Zoom Range | 28 to 105mm |
| Flash Duration | 1/300s - 1/20000s |
| Exposure Control | TTL |
| Groups | 5 |
| Flash Type | On-Camera |
| Compatible Systems | Olympus/Panasonic |
| Modeling Lamp | LED |
| Power Output | 1/1 - 1/256 |
| Swivel Angle | 330° |
| Flash Modes | Multi |
| Color Filter | Yes |
Essential safety guidelines to prevent injury, damage, or hazards during operation.
Details the key characteristics and capabilities of the flash unit.
Details the components and parts of the camera flash body.
Explains the buttons, dials, and indicators on the flash control panel.
Instructions on how to install and remove the battery from the flash unit.
How to read the battery level indicator on the LCD panel.
Information on how the flash unit manages power and auto-off functions.
Steps for attaching and operating the detachable sub flash SU-1.
Explanation of TTL auto flash mode and its features.
How to adjust flash exposure compensation for TTL mode.
Guide to using High-Speed Sync (FP Flash) with the camera.
Details on using manual flash mode for precise control.
Setting up the flash for S1 optic control (slave mode).
How to use the stroboscopic flash mode for continuous bursts.
Explains wireless transmitting/receiving flash shooting setup.
Example of setting up auto flash with a single receiver unit.
Example of setting up auto flash with multiple receiver groups.
Instructions to set the flash as a transmitter unit.
Instructions to set the flash as a receiver unit.
How to set wireless channels to prevent interference.
How to scan for available wireless channels.
Guide to performing TTL auto flash shooting.
Setting the transmitter unit's flash groups to manual mode.
Adjusting flash output for each group in manual mode.
Setting the transmitter unit for wireless multi-flash.
Adjusting multi-flash settings like output, number, and frequency.
Addresses interference issues with 2.4G signals.
Checks for flash recycle completion and over-heat status.
Addresses issues related to trigger and flash proximity.
How to use the sync cord jack for camera shutter synchronization.
How to use bounce flash for softer lighting effects.
How the low battery warning indicator works.
Setting the distance indicator display format.
Configuring the auto sleep setting for power saving.
Explanation of the over-temperature protection feature.
Guide to diagnose and solve common issues with the flash unit.
Instructions for upgrading the flash unit's firmware.
Compliance statement regarding FCC rules for radio frequency.
Important safety warning regarding operation and RF exposure.
Lists products and accessories covered by the warranty.
Steps to follow when seeking maintenance service.
Fields to be filled for product warranty registration.
Details on the product and component warranty periods.
