Need help?Do you have a question about the Godwin Dri-Prime HL200M and is the answer not in the manual?
Outlines the warranty policy for defects found after delivery, including repair or replacement terms.
Provides instructions and illustrations for safely lifting pump units using appropriate equipment.
Covers general safety practices for personnel working with the pump, including clothing and hazard awareness.
Details installation guidelines, including rotation direction, pump versions, and alignment.
Provides detailed steps for performing parallel and angular alignment using dial gauges.
Basic operational instructions and considerations before starting the pump unit.
Instructions for operating the pump in flooded suction, including necessary disconnections.
Procedure for disconnecting the compressor or vacuum pump for specific operational needs.
Details how and when to drain the pump and non-return valve, especially in cold weather.
Covers bearing types, re-greasing procedures, intervals, and potential issues from incorrect lubrication.
Explains the importance of seal coolant, checking levels, and potential consequences of dry running.
Provides a step-by-step guide for safely removing the mechanical seal from the pump.
Covers the critical steps and precautions for correctly fitting mechanical seals.
A table identifying possible causes of pump faults and their associated symptoms.
Provides designations, sizes, and performance capacities for CD, HL, and NC pump ranges.
General| Model | HL200M |
|---|---|
| Engine Type | Diesel |
| Power Source | Diesel Engine |
| Pump Type | Centrifugal |
| Discharge Size | 8 inch (200 mm) |
| Pump Size | 8 inch x 8 inch (200 mm x 200 mm) |
| Maximum Flow Rate | 2900 US GPM (659 m³/hr) |
| Maximum Head | 155 ft (47 m) |
| Solids Handling | 3 inch (75 mm) |
| Suction Lift | 28 ft (8.5 m) |
To Next Page