Need help?Do you have a question about the Godwin Dri-Prime HL250M and is the answer not in the manual?
Step-by-step guide for achieving correct pump and driver alignment.
Detailed steps for parallel and angular alignment using dial gauges.
Information on pump bearing types and maintenance requirements.
Guidance on the correct procedure for re-greasing pump bearings.
Checks and maintenance for mechanical seal coolant levels.
Safety warnings and initial steps for removing mechanical seals.
Procedure for removing the front cover and pump body to access internal components.
Detailed steps for safe removal of the pump impeller.
Instructions for removing the rear wear plate, including different pump types.
Specific procedures for removing various types of mechanical seals.
Critical precautions and preparation steps for fitting mechanical seals.
Ensuring parts are clean and free from burrs before seal assembly.
Step-by-step guide for correctly fitting mechanical seals to various pump types.
Steps for refitting the impeller, checking clearances, and torquing.
Procedures for dismantling bearing brackets and motor adaptors.
Detailed steps for dismantling bearing brackets and motor adaptors for various pump types.
Procedures for assembling bearing brackets and motor adaptors.
Step-by-step guide for assembling bearing brackets and motor adaptors.
General| Model | HL250M |
|---|---|
| Power Source | Diesel Engine |
| Pump Size | 250mm |
| Suction Size | 10 inch |
| Type | Automatic Self-Priming Centrifugal Pump |
To Next Page