EN
MAINTENANCE / CLEANING
• Always power off the device when cleaning it.
• Never use any harsh or strong solvents to clean the device since these may damage the surface of
the device. Dry, soft cloth is appropriate, however, if the device is extremely dirty, it may be wiped
off with a slightly moist cloth. Make sure the device is dried off after cleaning.
When you are necessary to ship the device, store it in its original package. Save the package for this
purpose.
TROUBLESHOOTING
ERROR REMEDY
The device does not
switch on.
• Check it the power adaptor is connected properly.
No sound.
• Turn on the sound as it may be muted. Increase the volume.
• Pull any connected headphone or speaker from the connector jack.
No network
connection can be
established.
• Check the WLAN function.
• Try to set an IP address at the device.
• Activate the DHCP function on the router and make the connection
again at the device.
• A firewall is activated on the network > set the respective program in
such a way that access is possible.
• Reboot the router
Hiss in FM mode.
• Check/move the FM antenna.
• Move the radio.
No stations available
/ burbling /
intermittent in DAB
mode.
• Move the radio.
• Rescan local stations only (high-strength).
• Check the local DAB coverage.
Alarm does not work.
• Switch on the alarm.
• Due to the volume setting, refer to the solutions of “No sound”.
• The source of alarm was set to be station but there is no network
connection. Change the source of alarm or reconfigure the connection.
All other undetermi-
ned cases.
The smart radio may process large amount of data after a period of
operation, no matter in which mode, it will cause the system freeze or
malfunction. Reboot the device if necessary.
The normal function of the product may be disturbed by strong Electro-
-Magnetic Interference. If so, simply reset the product to resume normal
operation by following the instruction manual. In case the function could
not resume, please use the product in other location.
The device may malfunction when used in areas with strong radio
interference. The device will work properly again once there is no more
interference.
To Next Page
Loading...
