Gold Note DS-10 EVO - Troubleshooting Common Issues

24
EN
DE
IT
| TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
The GN remote control
doesn’t control the DS-10
EVO.
The App can’t nd the
DS-10 EVO in the network.
| The GN remote control
can be used to control
more than one unit. To
control each unit the
correct mode must be
selected on the remote.
| Select DAC mode on the
remote.
The button “DAC” is
located in the upper part
of the remote.
| The DS-10 EVO is not
connected to the network.
| Make sure the DS-10
EVO is connected to the
WLAN or LAN either with
the Ethernet cable or the
Wi-Fi.
| Make sure the RF antenna
is correctly installed. It
may be impossible to use
the DS- 10 with the Wi-Fi
if the RF antenna is not
installed.
| When using Wi-Fi, make
sure the DS-10 EVO is
connected to the correct
WLAN. Don’t forget to
put in the password to
complete the connection
if required by your
network setup.
FR