Need help?Do you have a question about the GOLDONI MAXTER Series and is the answer not in the manual?
Cautions for safe operation, maintenance, and handling of the tractor and its equipment.
Information on tractor noise levels and user precautions regarding noise exposure.
Details of levers, pedals, and dashboard indicators for RS/R (steering wheel) models.
Explanation of various warning lights and gauges on the tractor's dashboard.
Details of levers, pedals, and dashboard indicators for SN/A (articulated) models.
Location and importance of tractor identification data found on the gear control plate.
How to use the lighting system and horn for various road and operating conditions.
Steps for using the ignition switch to start the tractor engine safely.
Procedure for safely shutting down the tractor's engine.
Instructions for operating the tractor's transmission, gears, and driving controls.
Step-by-step guide to safely bring the tractor to a complete stop.
Guidance on when and how to use the front and rear differential locks.
Information on engaging and using the independent and synchronised PTO.
How to operate the rear 3-point hydraulic lift using control levers.
Information on different modes for the tractor's hydraulic lift system.
How to use the hydraulic lift for raising, lowering, and floating implement operations.
Using the lift to maintain a constant implement position relative to the ground.
Using the lift to maintain constant draft, preventing engine overload and wheel slip.
Combining constant draft and height control for specific implement operations.
How to secure the hydraulic lift during on-road transfers to prevent implement dropping.
Importance of keeping the safety frame in the correct position and restrictions on modification.
Guidelines for using safety belts with the safety frame to reduce accident risk.
Reference to the engine instruction manual for engine-specific maintenance.
Locations of grease points and recommended grease for RS/R and SN/A models.
Procedures for checking and changing oil in the gearbox, differential, and hydraulic lift casings.
Procedures for cleaning lift oil filter and checking/changing oil in front axle and final drives.
How to maintain the radiator and clean/replace the air filter.
How to adjust the seat and recommended tyre inflation pressures.
General information on regulations and how to adjust clutch cable, brakes, and steering.
How to adjust the clutch pedal take-up using the adjusting screw.
How to adjust main and parking brakes, and linkage for braking performance.
Procedure for increasing steering radius by adjusting the steering cylinder.
Information on battery maintenance, air filter clogging gauge, and fuse circuits.
Indicative forward and reverse speeds in kph for RS/R models at 2600 Rpm.
Indicative forward and reverse speeds in kph for SN/A models at 2600 Rpm.
Approximate outside wheel widths in mm for various tyre sizes for RS/R and SN/A models.
Maximum load capacities in Kg for front and rear axles for different tyre sizes.
Schedule for checking and changing transmission oil, front axle oil, final drives, clutch fluid, filter, and air filter.
Technical specifications for various Agip oils, DOT 4 brake fluid, and Agip grease.
To Next Page
General