IM067B2 – June 2010
17
10. CLEANING INSTRUCTIONS
REMOVAL AND REPLACEMENT PARTS
1. BLOWER WHEEL REMOVAL
Shut off main power supply.
Remove the baffle by lifting up to free from keyhole slots.
Loosen the 2 allen-set screws on the wheel hub with 4/32” allen
key.Use wheel puller if the blower wheel does not come off readily.
2. BLOWER WHEEL REPLACEMENT
Lubricate blower wheel hub with high temperature compound or
graphite grease.Tighten allen set screws firmly and replace baffle.
3. MOTOR REMOVAL
Shut off main power supply.
Remove baffle (fan cover) from oven compartment.
Remove the 4 nuts around the blower wheel from the motor mount
panel with ½” wrench.
Grasp blower and tip forward into oven compartment.
With motor and panel inside, remove cover plate in rear of motor
and disconnect wires.
4. MOTOR LUBRICATION
None required, motor is self-lubricating.
5. MOTOR REPLACEMENT
Follow step in No.3 in reverse.
6. MICRO-SWITCH REMOVAL
Shut off main power supply.
Remove top nosing trim (4 screws) and disconnect wires from
micro-switch (top RHS of oven).
Undo nut holding micro switch.
Remove micro switch from housing.
7. MICRO-SWITCH REPLACEMENT
Follow steps in No.6 in reverse order.
Adjust screw if necessary. Micro-switch should be activated when
right hand door is about 50mm open.
8. ELECTRIC CONTROL REMOVAL
Shut off main power supply.
Disconnect wires from whichever control shall be removed.
Remove control panel by removing screw.
Blower switch.
IM067B2/p17
To Next Page
Loading...