IM067B2 – June 2010
3
1. INTRODUCTION
Congratulations for purchasing your Goldstein commercial cooking appliance.
J. Goldstein & Co. is a wholly owned Australian company and has been
operating since 1911, building high quality products. The information in this
manual will assist your installer and ensure correct location and connection.
Thoroughly read the user instructions and the user maintenance sections, as
understanding your products, its operation, and its cleaning and service
requirements will provide you with long and satisfactory service. Failure to do so
could shorten the life of the product and decrease its efficiency. Please ensure
only authorised service technicians are called to any difficulties that may arise.
INTRODUCTION
GOLDSTEIN GAS CONVECTION OVEN
MODEL X500A
GOLDSTEIN GAS CONVECTION OVENS are designed to give long and satisfactory
service and incorporate the best possible materials and workmanship. Proper
installation, adjustment and preventative maintenance are vitally important if efficiency
and appearance are to be maintained.
Read these instructions carefully as they contain important safety information regarding
the installation, use and maintenance of the appliance.
RECEIVING INSPECTION
•
Check crates for handling damage. After carefully uncrating, check for “concealed”
damage. Report any damage immediately to carrier and to dealer.
•
Remove check all loose items from unit and check contents as found on back of
warranty card.
•
Check type and capacity of gas supply & Electrical rating on the rating plate.
•
The type of gas for which this Oven is factory adjusted can be seen on the rating
plate, located on the front bottom panel (below the doors).
“THE EQUIPMENT MUST BE INSTALLED BY A LICENSED GASFITTER AND
LICENSED CONTRACTOR”
To Next Page
Loading...