golmar 3403

31
30
TELEPHONES PROGRAMMING
Switch off the telephone to be programmed.
Once the telephone is off, press the door release push button.
With the door release push button pressed
switch on the telephone.
To program the telephone as master,
switch it off and on again.
To program it as slave, press the door
release push button.
To program it as slave with intercom
function press the center push button.
MRBO T
R-3
TF-104
SEC
~~
CV+CV- D
Malla
Vin-AinAout Vin+ Vout-Vout++
CN1
-
INSTALLATION DIAGRAMS
onnexion of an a.c. lock release.
C
As it is described on page 21, the lock releases to be connected to the door panel
must be d.c. type. If an a.c. lock release has been installed before, use a R-3
relay unit and a TF-104 transformer, and connect them to the lock release
as it is shown on the enclosed diagram.
ink of several power supplies units.
L
If the quantity of monitors or telephones to be connected is bigger than the supported
from one power supply (see page 21), use additional power supplies to match the
required quantity. The first power supply should be connected to the door panel and
to the first group of monitors or telephones; connect the next groups to the positive
terminal of its corresponding power supply.
To wire several power supplies link their ground terminals;
NEVER link positive terminals of different power supplies.
To the door panel and to
the first group of monitors
or telephones.
To the second group of
monitors or telephones.
1st FA-Plus 2nd FA-Plus/C or FA-Plus
SEC
PRI
~~
Main
+ +
--
SEC
PRI
~~
Main
+ +
--
Door panel
rogramming the telephones.
P
golmar
13:15
O.K.
01
Each apartment must have one master unit only; in case of parallel units configure them
as slaves, both monitors or telephones.
Repeat these steps to program the rest of telephones.
Once the programming has been finished exit from the programming menu by pressing
CANCEL key. If you don't, the door panel will automatically exit after 90 seconds
with no operation.
In case of a general entrance door panel, program the telephones only from each internal
building door panel, as described on the corresponding instruction manual.
If this door panel is installed on an internal building of a residential complex or on a single
building, program the telephones as follows:
To enter the door panel into program mode, press
key symbol and enter the installer PIN code
(factory default: 1315), as described on page 10.
Enter the code that will be used to call to
this telephone and press the bell key.
At this moment the panel will reproduce
a sound and the telephone led will blink.
To show that the system is ready for programming, the panel
will reproduce a sound and the LCD will display the
message program mode. At this moment, the door
release push button can be released. Lift the handset
to stablish audio communication with the door panel.
1
4
7
2
5
8
3
6 0
9
C