golmar T562 GB2 User Manual

5
1 2 3
ON
4 5
Co 16de
1 2 3
ON
4 5
Co 20de
1 2 3
ON
4 5
Co 24de
1 2 3
ON
4 5
Co 28de
1 2 3
ON
4 5
Co 23de
1 2 3
ON
4 5
Co 17de
1 2 3
ON
4 5
Co 21de
1 2 3
ON
4 5
Co 25de
1 2 3
ON
4 5
Co 29de
1 2 3
ON
4 5
Co 27de
1 2 3
ON
4 5
Co 18de
1 2 3
ON
4 5
Co 22de
1 2 3
ON
4 5
Co 26de
1 2 3
ON
4 5
Co 30de
1 2 3
ON
4 5
Co 31de
1 2 3
ON
4 5
Co 19de
" :Doctor mode function"
Descrip :tion
The doctor mode function allows lock release 1 to activate automatically 3 seconds after making a call from the door" "
panel without having to establish communication or press the lock release push button. The call ends after 7
seconds and the channel is freed. (Only the master telephone must be configured with “doctor mode” function).
Activating "doctor mode":
The telephone must be in standby mode to activate doctor mode" ":
Move the volume adjustment to the OFF position.
The telephone must be in standby mode to deactivate doctor mode" ":
Move the volume adjustment away from the OFF position to a medium or maximum position depending on the desired
call volume.
Enabling doctor mode :" "
To enable doctor mode , access the configuration dip switch located inside" " on master telephone
the telephone and set Dip 12 to ON.
11 129 10
ON
Continues from the previous page.
1 2 3
ON
4 5
Co 12de
1 2 3
ON
4 5
Co 13de
1 2 3
ON
4 5
Co 14de
1 2 3
ON
4 5
Co 15de
Intercom function:
Intercom functionality between two points in the same apartment comes as standard in the T562 GB2 telephone.
The telephone must be in standby to make intercom calls.
To communicate over the intercom, lift the handset and press the intercom push button. The apartment monitor(s)
being called will emit an audible tone confirming the call is in progress.
There is a period of 40 seconds to attend to the call.
To establish communication lift the handset of the called telephone (or any other one if there is more than one slave
telephone).
The communication will last for one and a half minutes or until the handset is replaced.
T562 G 2B TELEPHONE
TELEPHONE DESCRIPTION
Activation light function:
The terminal must be in standby and with the handset on the craddle to activate the light (it requires of SAR-GB2 and
SAR-12/24 modules).
To activate light function (for example "stairs light"), press the push button.
Important: For the wire and configuration, see TSAR-GB2 and TSAR-12/24 manuals.

golmar T562 GB2 Specifications

General

Brand	golmar
Model	T562 GB2
Category	Telephone
Language	English