Problem Possible cause Solution
Excessive vibration.
The appliance is not installed
properly on the brackets.
Remove the appliance and check it
is properly fixed.
The fan motor does not
work
The fan blade is jammed.
The motor is damaged.
Switch off the appliance. Ring the
customer helpline at the end of
the Care & maintenance section to
arrange an engineer visit.
Power connection loose. Check power supply
Suction performance
reduced.
Speed may be too low. Select a higher speed.
Aluminium filters are dirty.
Clean the aluminium filters. (See
Care and maintenance section)
Bottom vent might be
obstructed.
Clear any obstruction.
Optional vent kit might be
twisted.
Ensure that the vent kit is fitted
according to the manufacturers’
instructions.
The installation may
not comply with the
manufacturers’ instructions.
The vent hose should be the correct
diameter (150mm) throughout, with
no reduction or restriction. (See the
Installation section of this manual).
Works normally but
cooking smells linger.
Carbon filter is not fitted in
recirculation mode or is full of
grease.
Fit or replace the carbon filter in the
recirculation kit. (See the Care and
maintenance section of this manual).
EN
Extractor fan troubleshooting
EN Extractor fan troubleshooting FR Dépannage du ventilateur d’évacuation
PL Wykrywanie i usuwanie RODepanare ventilator de evacuare
30