To Next PageTo Next PageWhat to do if my Goodman furnace fails to operate because of circulator blower motor voltage or temperature issues?
If your Goodman furnace fails to operate because the circulator blower motor shuts down due to over or under voltage conditions or due to an over temperature condition on the power module, check the voltage to the furnace and verify it's within the nameplate specified range.
What to do if my Goodman GMVS960805CU AA Furnace fails to operate because of aux switch open?
If your Goodman furnace fails to operate because the aux switch (condensate switch) is open, check the evaporator drain pan, trap, and piping.
General| Model | GMVS960805CU AA |
|---|---|
| Type | Gas Furnace |
| Efficiency Rating | 96% AFUE |
| Heating Capacity | 80, 000 BTU |
| Blower Motor | Variable Speed |
| Fuel Type | Natural Gas |
| BTU Input | 80, 000 BTU |
| BTU Output | 76, 800 BTU |
| Stages | Two-Stage |
| Configuration | Upflow/Horizontal |
| Brand | Goodman |
| Category | Furnace |
| Motor Type | ECM |
| Warranty | 10-Year Parts Limited Warranty; Lifetime Heat Exchanger Limited Warranty |
Essential safety notices and warnings for users and service personnel.
Guidance on understanding safety symbols, words, and labels for hazard identification.
Details on furnace model identification and component part naming conventions.
Critical safety precautions to be followed during installation, adjustment, and operation.
Instructions for connecting a 24-volt thermostat to the furnace control system.
Overview of the phone application for setup, diagnostics, and system adjustments.
Recommended annual inspection checklist for ensuring proper furnace operation and safety.
Step-by-step guide to measuring the furnace's gas input rate using a gas meter.
Diagram identifying key components of the furnace for servicing.
Procedures for measuring and verifying electrical voltage levels within the furnace.
Method for measuring and adjusting the temperature rise for optimal heat exchanger performance.
How to measure and adjust gas supply and manifold pressures for correct operation.
Testing the flame sensor for proper micro-amp signal and cleaning if necessary.
Description of various menu options available for furnace configuration and diagnostics.
List and description of LED display status codes for system diagnostics.
How to access and interpret the last six fault codes detected by the furnace.
