Troubleshooting5
Problem What to do
No sound
Sound is distorted
FM:Static sound
DAB+:Burbling/
intermittent cut-out
The station is not tuned in. Fine tune the
station.
The volume is set to a low position.
Increase the volume.
Signal reception is too low. Adjust the
aerial or move the unit to a stronger
signal location.
Rescan stations.
The volume is too high. Adjust the
volume control.
Desired station not
found
Weak signal. Use the manual
tune function.
There is no DAB+ coverage in your
area, or poor reception. Adjust the
position of the aerial, or move the until
to a stronger signal location.
This may occur if the broadcaster
changes the label of a service or
removes a label while tuned.
The unit will try to retune or perform
a scan.
Display shows
“No Service”
Display is blank
To Next Page
Loading...
