FLAT
SURFACE
MOUNTING
CURVED
SURFACE
MOUNTING
Mount your GoPro to helmets, gear and more with the included
Curved + Flat Adhesive Mounts and hardware.
MOUNTING YOUR
CAMERA
TIP:
Apply adhesive mounts to clean, smooth surfaces at room
temperature only, at least 24 hours before use. To remove, heat
with a hair dryer then peel off mount.
Your HERO+ LCD camera comes with three backdoors, each
designed for different uses and environments.
STANDARD BACKDOOR
Provides waterproof protection to 131’ (40m).
Use when shooting under water or in wet,
damp or dirty conditions.
TOUCH BACKDOOR
Enables access to the touch display.
Provides waterproof protection to 10’ (3m).
(To prevent damage to the touch display, do not exceed this depth when
using this backdoor. Touch functionality is not available under water.)
SKELETON BACKDOOR
Not waterproof—use in dry, dirt-free
environments only. Enables access to the
touch display, provides enhanced cooling and
allows more direct access to the microphone.
HOUSING
BACKDOORS
To Next Page
Loading...
Need help?
General
