solvents, alcohol, ammonia or abrasives to clean LCD
Touch BacPac.
AVOID WATER AND WET LOCATIONS
Do not use unprotected LCD Touch BacPac in rain or
near washbasins or other wet locations. Do not spill food
or liquid onto the LCD Touch BacPac. If the LCD Touch
BacPac gets wet, turn off the camera and disconnect be-
fore cleaning. Allow to dry thoroughly before using again.
Do not dry the LCD Touch BacPac with an external heat
source such as a microwave oven or hair dryer. Damage
to the LCD Touch BacPac caused by contact with liquid is
not covered under the warranty.
ALTITUDE AND TEMPERATURE CHANGES
Increases or decreases in altitude and temperature can
cause the Touch Backdoor to bulge slightly when housing
is sealed closed (with or without camera inside). Where
possible, leave door open until ready to use.
USING CONNECTORS AND PORTS
Never force a connector into a port; check for
obstructions on the port. If the connector and the port do
not join with reasonable ease there may be a mismatch.
Be sure the connector matches the port and that
connections line up.
23
To Next Page
Loading...
Need help?
General
