Settings
Open the settings menu:
First, open the door. Turn off the machine. Press and hold the main power switch until the display
lights up.
1.
Within 10 seconds:
- press the program button for Auto wash and the option button for SpeedWash.
2.
+
The display shows the settings menu (current setting and its currently set value).3.
(Exit the menu by browsing through the menu or pressing the main power switch.)
Navigate the settings menu:
Press to save the setting value and continue to the
next setting.
Current setting.
Current setting value.
Press to browse between setting values.
You can now adjust the following settings:
OptionsSettings
Rinse aid dosage setting.1:00 - 1:05Rinse aid1.
Increase the rinse aid dosage:
• If the dishes have water marks.
Reduce the rinse aid dosage:
• If the dishes have a sticky white/blue film.
• If the dishes are streaked.
• Heavy foaming. If you have very soft water, the rinse
aid can be diluted 50:50 with water.
Adjusting the water softener. Read off the appropriate
setting from the water hardness table below.
°dH
0-5
6-8
9-11
12-14
15-19
20-24
25-29
30-39
40-49
50+
0-9
10-14
15-20
21-25
26-34
35-43
44-52
53-70
71-88
89+
°fH
°dH
°fH
2:00 - 2:09Water hardness2.
Do not forget to put salt in the salt compartment after
you have set the water softener to 2:01 - 2:09.
For a water supply with a hardness under 6°dH (9°fH),
select 2:00. The water softener is deactivated and no
salt is needed.
12
To Next Page
Loading...
Need help?
General
