36 GMC-I Messtechnik GmbH
14.5 Optional Accessories (not included)
ISO Calibrator 1 (material no. M662A)
Calibration adapter for testing the accuracy of instru-
ments used for measuring insulation resistance and
low-resistance for test voltages up to 1000 V (per VDE
0413, parts 1, 2, 4 and 10)
KS-C (material no. Z541F)
Cable set consisting of measurement cable and
shielded high-resistance measurement cable for mea-
surements in the GΩ range
KY95-3 (material no. Z110J)
(
METRISO BASE/TECH: scope of delivery 1 piece)
Alligator clips (1 pair) for KS17-4 and KS-C
1081 probe (material no. GTZ3196000R0001)
Triangular probe for floor measurements per EN 1081,
DIN VDE 0100-600 (Standing-Surface Insulation)
KS24 (material no. GTZ3201000R0001)
Cable set consisting of a 4 m long extension cable with
a permanently attached test probe at one end and a
contact protected socket at the other end, and 1 alli-
gator clip which can be plugged onto the test probe
Test Probe for Remote Triggering
(material no. Z550A)
Optional plug-on measurement cable with a triggering
key on the test probe and an additional key for illumi-
nating the measuring point, including shielded, plug-in
connector cable.
14.5.1
Application Test Probe for Remote Triggering (Option Z550A)
When inserting
the 3-pole plug,
make sure that
the jack plug is
inserted in the
START/STOP
position. Press
and align the 3-
pole plug such
that it is placed
flush on the con-
nection terminal.
This is the only
way to assure
that the three
contacts of the
jack plug are
properly con-
nected with the command cables.
(G500/G1000)
START/STOP SHIELD COM
Option Z550A
+
To Next Page
Loading...
