Gossen MetraWatt PROFITEST MBASE MTECH User Manual

Name: Gossen MetraWatt PROFITEST MBASE MTECH
Brand: Gossen MetraWatt
Rating: 4 (1 reviews)

64 pages

To Next Page

Operating Instructions

PROFITEST MBASE MTECH

Test Instruments for IEC 60364.6 / DIN VDE 0100

3-349-470-03

9/4.12

Default Chapter3
- Display Panel3
1 Scope of Delivery4
- Table of Contents4
2 Application5
- Overview of Features Included with Different PROFITEST ASTER Variants5
- Master5
3 Safety Features and Precautions6
- Switching the Instrument on and off6
- Device Settings7
- Automatic Settings, Monitoring and Shut-Off10
- Connecting the Instrument10
4 Initial Start-Up6
- Installing or Replacing Rechargeable Batteries6
- Preparation for Use6
5 General Instructions10
- Measurement Value Display and Memory10
- Testing Earthing Contact Sockets for Correct Connection10
- Help Function11
- Setting Parameters or Limit Values Using RCD Measurement as an Example11
- New! Freely Adjustable Parameters or Limit Values12
- New! Two-Pole Measurement with Rapid or12
  - Semiautomatic Polarity Reversal12
- As Well as N and PE13
  - (U N-PE ) for Country-Specific Plug Insert, E.g. SCHUKO13
6 Measuring Alternating Voltage and Frequency13
- Single Phase Measurement13
- Voltage between L - PE, N - PE and L - L for Connection of 2-Pole Adapter13
- Voltage between L and N13
  - L-N ), L and PE13
- 3-Phase Measurement (Line-To-Line Voltage) and Phase Sequence14
7 Testing Rcds14
- Measuring Contact Voltage15
  - Nominal Residual Current15
- Special Testing for Systems and Rccbs17
- Testing Systems and Rccbs with Rising Residual Current (Alternating Current) for Rcds Type A, AC and B17
- Testing Systems and Rccbs with Rising Residual Current (Direct Current) for Rcds Type B17
- Testing Rccbs Which Are Suited for Pulsating DC Residual Current18
- Testing RCCBS with 5  I18
- 7.3.1 Systems with Type RCD-S Selective Rcds19
- 7.3.2 Prcds with Non-Linear Type PRCD-K Elements19
- Testing for Special Rcds19
- Srcds, PRCD-S (SCHUKOMAT, SIDOS or Comparable)20
- 7.3.4 Type G or R Rccbs21
- Testing Residual Current Circuit Breakers (Rcds) in IT Systems with High Wiring Capacitance (E.g. in Norway)22
- Testing Residual Current Circuit Breakers in TN-S Systems22
- And I K )23
8 Testing of Breaking Requirements Overcurrent Protective Devices, Measurement of Loop Impedance and Determination of Short-Circuit Current23
- Measurement with Positive Half-Waves (Only PROFITEST MTECH )24
- Measurements with Suppression of RCD Tripping24
- Evaluation of Measured Values25
9 Measuring Line Impedance (Z L-N Function)25
10 Earthing Resistance Measurement27
- Earthing Resistance Measurement (Function R )27
- Measuring with Probe28
- Measuring Without Probe29
- Measuring Earth Electrode Potential (Function U E )30
- Selective Earth Resistance Measurement with Accessory Current Clamp Sensor31
11 Measuring the Impedance of Insulating Floors and Walls (Standing Surface Insulation Impedance ZST )33
- General34
12 Measuring Insulation Resistance34
- Special Case: Earth Leakage Resistance (REINS )36
13 Testing Meter Start-Up with Earthing Contact Adapter37
14 Measuring Low-Value Resistance of up to 100 Ohm (Protective Conductors and Protective Equipotential Bonding Conductors)38
15 Measurement with Accessory Sensors40
- Measuring Current with a Current Sensor Clamp40
- Creating a Distributor Structure in the Test Instrument41
- Creating Distributor Structures, General41
16 Database41
- Transferring Distributor Structures41
- Structure Creation (Example for Electrical Circuit)42
- 16.3.2 Searching for Structural Elements43
- Data Storage and Reporting44
- 16.4.1 Using Barcode and RFID Readers45
17 Operating and Display Elements46
18 Characteristic Values48
- LED Indications, Mains Connections and Potential Differences51
- Charging Procedure with the Z502P Charger (Accessory)56
- Firmware Revision and Calibration Information56
- Fuses56
- Housing56
19 Maintenance56
- Rechargeable Battery Operation and Charging56
20 Appendix57
- Tables for the Determination of Maximum or Minimum Display Values under Consideration of Maximum Instrument Operating Uncertainty57
- Testing Electrical Machinery Per DIN en 60204 - Applications, Limit Values59
- Limit Values for Electrical Systems and Equipment60
- Periodic Testing Per BGV A360
- List of Abbreviations and Their Meanings61
- Index62
- 20.6.1 Internet Addresses for Additional Information63
- Bibliography63
- DKD Calibration Certificate64
21 Repair and Replacement Parts Service Calibration Center and Rental Instrument Service64
22 Recalibration64
23 Product Support64

Other manuals for Gossen MetraWatt PROFITEST MBASE MTECH

Short-Form Operating Instructions20 pages

Questions and Answers:

Need help?

Do you have a question about the Gossen MetraWatt PROFITEST MBASE MTECH and is the answer not in the manual?

Gossen MetraWatt PROFITEST MBASE MTECH Specifications

General

Brand	Gossen MetraWatt
Model	PROFITEST MBASE MTECH
Category	Measuring Instruments
Language	English

Related product manuals

Gossen MetraWatt DIGISIX 2

48 pages

Gossen MetraWatt SECUTEST PRO

90 pages

Gossen MetraWatt METRISO G1000

36 pages

Gossen MetraWatt METRA HIT 22S

60 pages

Gossen MetraWatt PROFITEST MBASE MTECH User Manual

Table of Contents

Other manuals for Gossen MetraWatt PROFITEST MBASE MTECH

Questions and Answers:

Gossen MetraWatt PROFITEST MBASE MTECH Specifications

Related product manuals