Wheel diameter setting: St.1 represents the wheel diameter setting. Because
adjusting the wheel diameter will result in inaccurate speed display and mileage
display, this setting cannot be adjusted.
Speed limit setting: st.2 means speed limit setting. The factory default value of
maximum riding speed is 32KM/h (20MPH).
Backlight Brightness: st.3 stands for backlight. Parameters 1, 2, and 3 can be set,
and the factory default value is 2. The parameters of the backlight brightness can be
changedbypressingthe + button or — button. 1 isthe darkest,2 is medium,and3
is the brightest.
KM/MPHswitching: st.4representsKM/MPHswitching.Shortpressthe + button
or — button to switch between KM and MPH.
Exit setting: In the setting mode, press and hold the M button for 2 seconds to
confirm and save the current setting and exit the current setting.
If no operation is performed within one minute, the meter will automatically exit the
setting.
25
To Next Page
Loading...
