Scooter Console Functions
Long press power button to power on and off.
Hold “+” button for 3 seconds to power the headlight and tail light power on and off.
To unlock the display lock the password is 000. Use the “ + “ button to input 0 and
press the power button to set. Repeat the process to enter in the full code 000. Once all three
zero’s have been selected, press the power button twice to deactivate the lock.
To set your own code, press the “ + “ button and the power button together for 10
seconds. Then use the “ + “ button to input the rst number of your code and press the power
button to set. Repeat the process to set your own individual three number code. Once your
three number code is selected, press the power button twice to deactivate the lock.
Press the throttle for 8 seconds to activate Cruise Control while moving. Press the
handbrake to cancel the cruise control feature.
Hold the “ - “ button while walking next to the scooter to activate push assist mode. Once
the push assist mode has been activated the scooter will move at 1.8 mph to make it easier to
walk next to the scooter.
The console on the scooter displays speed in MPH, Distance, Battery life, and the Headlights.
To lock the tiller lock, adjust the password wheel to show “0000”. Pull the lock pin and
insert it into the lock hole. Scramble the password wheel to lock.
To unlock the tiller lock, adjust the password wheel to show “0000”. Press the button and
pull out the lock pin from the lock hole and insert the lock pin cord back into the tiller.
To set your own code, Adjust the password wheel to show “0000” and then push the set
button to the “set” position. Adjust the password wheel to the four digit code of your choice
and then push the set button back to the left.
To Next Page
Loading...
Need help?
General
