Assemble Your Scooter
Assemble the front wheel compartment and
rear wheel compartment together, Take the
4 screws and use the 5mm Allen Wrench
to tighten the screws. Once the screws are
tightened, open the kickstand and straighten
the scooter out.
ASSEMBLE FRONT AND REAR WHEEL
COMPARTMENTS
Take the tiller component and insert the tiller
into the head tube, use the 4mm Allen wrench
to tighten.
INSERT TILLER INTO THE HEAD TUBE
WITH WRENCH
Use 4mm Allen wrench to remove the screws
from the block on the top of the tiller, put the
handlebar on and cover with the top of the
block. Tighten the screws. Test the scooter
after you’ve nished assembling.
REMOVE SCREW FROM BLOCK
ON TOP OF THE TILLER
1
2
3
To Next Page
Loading...
Need help?
General
