Troubleshooting:
issues is calibrating your board. Here are the steps involved in
1. Start with the hoverboard powered off.
2. Adjust the foot pedals until they are level with each other and the
ground.
3. Press and hold the power button for 10 seconds. The LED lights will
4. Press the power button to turn off.
5. Press the power button to turn on. The hoverboard will be calibrated
and ready for galactic adventures.
NOTE: You may have to repeat the above process multiple times in order
to fully reset and calibrate your hoverboard. For example, you may have
to go through the process 3 times in a row before the calibration fully
takes effect.
To Next Page
Loading...
Need help?
General
