Maintenance & Repair
If you regularly clean and maintain your electric scooter, it will extend its life.
Cleaning and storage: If the scooter is dirty, wipe it clean with a soft damp
cloth.
Disc Brake Adjustments: If the brake is too tight, use a 4m Allen wrench to
loosen the screws counterclockwise. Push the brake wire to shorten and lock
the screw in place. If the brake is too loose, loosen the screws and pull the brake
wire to extend the wire and lock the screws.
Tiller Adjustments: If the tiller wiggles while riding, please check the set screws.
Use an Allen wrench to tighten the screws as the figure shows.
Tires: If you notice that the tire pressure is low, please fill to the recommended
PSI on the side of the tire, Recommended PSI: 36
DO NOT use alcohol, gasoline,kerosene, or other corrosive chemical solvents
to clean the scooter. It can severely damage the appearance and structure of
the scooter. Please do not use a pressure washer as it may also cause damage
to the electronics.
Storage: When you’re not using your scooter store in a dry and cool location.
Avoid storing your scooter outdoors because sun exposure can damage it’s
appearance and may cause wear on the life of the battery and tires.
12
To Next Page
Loading...
